Tables will be designed so that customer cutting tool can be placed on the table to be placed under the cutting head for bolting the tool to the cutting head.
Table capable of holding up to 2,500lb tool
Tables to be powered via an air cylinder (standard – not rodless). Operator station with cycle start activation buttons will be mounted at the end of each table for operator convenience
Light curtains included on each side of machine for safe operation
Corner brackets (quantity to be determined at time of engineering) will be included so that operator can properly position the Sheet Material to ensure it aligns with the cutting die when the table enters the cutting area Cutting Press.
– Nylon cutting pad on each table.
– Oscillating Pad Shifter
– Designed to incrementally move the cutting pad after each stroke to prevent the cutting die from cutting into the same location on the pad after each stroke. One pad shifter to be installed on each table (2 shifters TOTAL)
-Will drastically increase the life of the cutting surface
-Material alignment brackets will be mounted so that they are not affected by the pad oscillating to ensure that the material
aligns with the die before being cut
Stroke Control – Controlled by Linear Transducer which allows the die height to be adjusted infinitely in increments of 0.001”