Die Cutting Fiberglass Insulation HVAC Material

Die Cutting Fiberglass Insulation HVAC Material on Belt Clamp Feed System

SCHWABE USA Straight Ram Hydraulic Beam Press SR230

Fiberglass is used as resilient blankets for liquid natural gas tanks, pipe insulation, duct liners and die cut for HVAC insulation applications e.g. temperature insulation, acoustical insulation pads and blankets.

Watch Video Demo below on Freeman Schwabe YouTube Channel

The Demo shows one layer of HVAC material being cut, the SCHWABE USA SR press is capable of cutting multiple layers of the material.

Demo Material : Minimum material thickness: 1⁄2” Maximum material thickness: 6”

Min material width: 36” Maximum material width: 65”

Die Cutting Fiberglass Insulation HVAC Material

General Specifications

Country of Manufacture – USA
Cutting Force – 230 U.S. Tons
Bed Size – 70”W x 75”D
Head Size – 71”W x 76”D
Die boards are 70”W x 75”D plus up to a half inch on each side. Extra 1” added to the platen to allow for die boards to easily slide into the die rails when in there out most position
Cutting Stroke – 8”
Daylight Opening – 9” from head to bed without cutting surface.
Cutting Surface – Nylon Belt

Cutting Speeds

SR230, with no mechanical stops and clamp feed, 2” cutting stroke, 75” material feed using 40IPS servo drive = 9-9.5 strokes a minute using 54GPM unit at 3000PSI

Safety

Safety Guarding – Meets or exceeds all OSHA machine safety requirements including specification 1910.217(f) as interpreted by Manufacturer.
Head Safety Block – For working under the head of the press.
E-Stop Safety Relays – These relays provide 3 primary functions:
Detect faults on safety-related electrical control circuits (i.e. faults in sensors, wiring, contactors, etc.)
Provides an ensured switching action.
Provides a manual reset facility.
Outfeed guarding

Feed System

Type – Clamp feed/ belt combination
Continuous belt traveling through press, utilized as a material carrier and cutting surface, transported by a rear (in-feed) mounted pneumatic clamp feed unit, with no staging area beyond the guard.Clamp feed system complete with one movable pneumatically actuated clamp bar with linear bearing guide for smooth, precise travel. Also includes one pneumatically actuated fixed clamp bar with manual controls located on in feed side of press. Moveable clamp is powered by a Servo Drive for accurate positioning of the cutting belt.

This entry was posted in fiberglass, Fiberglass Insulation, Schwabe Die Cutting and tagged , , , , . Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s